This question is related to Product Eport-E20 with latest FW 1.40.5: How is it possible to set and configure the PINs named GPIO1 (PIN number 1) and GPIO2 (PIN number 2) as Output pins and control them via software, webinterface or cmdline? It should be possible acc. to extracted page 8 from Manual Do you have any instructions that explain the procedure? Many thanks in advance for your reply.

This question is related to Product Eport-E20 with latest FW 1.40.5: How is it possible to set and configure the PINs named GPIO1 (PIN number 1) and GPIO2 (PIN number 2) as Output pins and control them via software, webinterface or cmdline? It should be possible acc. to extracted page 8 from Manual Do you have any instructions that explain the procedure? Many thanks in advance for your reply.

This question is related to Product Eport-E20 with latest FW 1.40.5: How is it possible to set and configure the PINs named GPIO1 (PIN number 1) and GPIO2 (PIN number 2) as Output pins and control them via software, webinterface or cmdline? It should be possible acc. to extracted page 8 from Manual Do you have any instructions that explain the procedure? Many thanks in advance for your reply.

This question is related to Product Eport-E20 with latest FW 1.40.5: How is it possible to set and configure the PINs named GPIO1 (PIN number 1) and GPIO2 (PIN number 2) as Output pins and control them via software, webinterface or cmdline? It should be possible acc. to extracted page 8 from Manual Do you have any instructions that explain the procedure? Many thanks in advance for your reply.

设备无法给电脑分配IP，导致电脑搜索不到设备

Iot master无法下载