模块上电后电脑wifi无法扫描到模块的AP，且串口也无法连接上，测试了CLK引脚脚没有时钟信号，

HF9606第一次使用，没有调试软件，目前不会使用

上电运行一段时间后，就ping不通EW11了

This question is related to Product Eport-E20 with latest FW 1.40.5: How is it possible to set and configure the PINs named GPIO1 (PIN number 1) and GPIO2 (PIN number 2) as Output pins and control them via software, webinterface or cmdline? It should be possible acc. to extracted page 8 from Manual Do you have any instructions that explain the procedure? Many thanks in advance for your reply.

This question is related to Product Eport-E20 with latest FW 1.40.5: How is it possible to set and configure the PINs named GPIO1 (PIN number 1) and GPIO2 (PIN number 2) as Output pins and control them via software, webinterface or cmdline? It should be possible acc. to extracted page 8 from Manual Do you have any instructions that explain the procedure? Many thanks in advance for your reply.

This question is related to Product Eport-E20 with latest FW 1.40.5: How is it possible to set and configure the PINs named GPIO1 (PIN number 1) and GPIO2 (PIN number 2) as Output pins and control them via software, webinterface or cmdline? It should be possible acc. to extracted page 8 from Manual Do you have any instructions that explain the procedure? Many thanks in advance for your reply.